InterceptRadio.com Forums

Hell0, I have a pro433 and would give a kings ransom if somebody would take me step by step on how to program trunk numbers into it. Thank you very much.

Assuming you are in King County, here is how to do it:

(1) Go to page 24 of the instruction manual:
http://rsk.imageg.net/graphics/uc/rsk/Support/ProductManuals/2000433_PM_EN.pdf

(2) select "E2-800" (step 3 on page 24)

(3) enter these frequencies (step 5 on page 24)
http://interceptradio.com/s.php?sfreq=4&ssort=1&spl=3D1C&cfreq=1&sfq=Site%2005&z=1

(4) enter the talkgroups you are interested in listening to (step 5 on page 26)
http://interceptradio.com/s.php?sfreq=2&ssort=1&spl=3D1C&cfreq=1&z=1

it was a horrible film

http://www.imdb.com/title/tt0388183/

_________________
If I had an antenna, I would; but I can only transmit on 160 meters.
_____
DE K7MHI

No doubt. If he were to throw in a Shaun of the Dead, or maybe a THX 1138....... then I'd consider helping him. Hell, I'd even go for a Corvette Summer (Mmmmmm, fast cars and cheese) :)

Jokes aside, overvoldy. Follow the steps that Rich provided, and you should have no problems. Good luck and welcome.

Hello; I have a radio shack pro-433 scanner and I am trying to program in trunk numbers. But I just get error signs when I try to put them. I have followed the instructins perfectly right to the end whenm you are supposed,to install the numbers; and the it just says error. There are five numbers and some of them have a T in front of the numbers; whatever that means. Could anybody help this dummy with this problem? I would sure appreciate it. Thank you. Fritzy