InterceptRadio.com Forums
http://interceptradio.com/bbs/

Firewall
http://interceptradio.com/bbs/viewtopic.php?f=3&t=2918
Page 1 of 1

Author:  Mark [ Sun Jun 28, 2009 9:38 pm ]
Post subject:  Firewall

Trying to get two power wires through my 2002 Toyota Sienna firewall. Any good ideas. My drill is at the ready. I have found no pop-outs and am a bit scared about the drill. Thanks.

-m

Author:  Atomic Taco [ Sun Jun 28, 2009 11:09 pm ]
Post subject:  Re: Firewall

If you're near a library you can pull up the Chilton's or All Data online. Actually if you have a KCLS card you can pull up Chilton's online. KCLS and SPL.

Author:  chpalmer [ Sun Jun 28, 2009 11:15 pm ]
Post subject:  Re: Firewall

Automatic Tranny or stick? I find on automatics the clutch popout plate is a good place usually.

Author:  Mark [ Mon Jun 29, 2009 6:36 am ]
Post subject:  Re: Firewall

So when Sean says 'don't violate your firewall' why does it sound dirty. Thanks for the ideas. Off to find power on the fuse block.

Author:  SpudGunMan [ Mon Jun 29, 2009 1:10 pm ]
Post subject:  Re: Firewall

or find another rubber boot and cut a small hole in it. never hole your firewall.

Author:  chpalmer [ Mon Jun 29, 2009 9:54 pm ]
Post subject:  Re: Firewall

Ive been known to use a body plug next to the door hinges, and route into the fender on some cars. Usually when we mount a fender antenna.

Allot of broadcast radio antennas are routed this general direction also...

Author:  Mark [ Mon Jun 29, 2009 10:09 pm ]
Post subject:  Re: Firewall

If I have no luck with the fuse block the fender is my next choice. Only thing this car does not have is rear DVD and that's where I'm going. Thanks.

Author:  Vizwar [ Tue Jun 30, 2009 9:54 am ]
Post subject:  Re: Firewall

Mark wrote:
Trying to get two power wires through my 2002 Toyota Sienna firewall. Any good ideas. My drill is at the ready. I have found no pop-outs and am a bit scared about the drill. Thanks.

-m


I made a new hole in an existing grommet on my car and then sealed it up after snaking the cables through.

Page 1 of 1 All times are UTC - 8 hours
Copyright © 2013 Interceptradio.com